I recently got hold of the Oculus Rift DK1 but ran into a bit of a problem with the fact that my Nvidia card only has four display outputs which all were already in use. So to use the Rift I’d need to unplug one monitor, use a HDMI switch or a HDMI splitter. The splitter seemed like the best option but active splitters seemed very expensive and I read about EDID problems with passive splitters.
The EDID problem comes when you have two displays (a monitor and the Rift) at the end of the single HDMI output and Windows (or the video card) pretty much randomly uses the EDID from either one – and when it uses the one from the monitor the Oculus SDK will not detect the Rift as being attached and cannot read the information from it. A way to avoid this issue is to plug in the Rift first, let windows detect it and then plug in the monitor. But this is clumbersome and needs to be done on every reboot so it is not very practical.
Thinking about what to do about this the solution was simple: Make Windows not see the desktop monitor at all by cutting off the DDC pins from the HDMI cable that goes to the monitor. DDC is used for communicating the EDID and with those gone Windows will only be able to talk to the Rift. This of course means the Rift must be attached to have something visible in the monitor and the monitor will be limited to resolutions supported by the Rift, but in my case this is not a problem as the Rift reports it can support 1920×1200 which is the native resolution of the monitor I use.
In practice the easiest way to get rid of the DDC pins was to remove them from a HDMI to DVI adapter that goes to the monitor. In the DVI connector DDC data & clock are in pins 6 and 7:
These were easy to remove with a pair of pliers, you need to be a bit careful to not bend the other pins too much but these adapters are also very cheap so its not a huge loss for it to go wrong. My result:
I use this with a cheap passive HDMI splitter that cost 10 euros and it works well. One problem I did notice is that if I turn off the Rift box I get some signal errors visible on the monitor image, possibly the signal gets too weak when the unpowered Rift box is attached in the cable. It can be avoided by just keeping the Rift powered at all times or by unplugging the power cable from the Rift box instead of just turning it off (Reading the EDID from the Rift still works even with the box unpowered). Some shorter cables might help as well.
edit: Also I noticed that when you unplug the USB cable the rift display turns off so it is an easy way to unpower the rift when its not in use, while keeping the control box on.
Hi man, thank you for all your clever tips about Assetto Corsa and Oculus Rift. I want to ask you something about this trick, the DK2 work @75hz and my crappy TV monitor can work only @59hz or @60hz. Do you think it could work anyway? Thank you.
Hello. No it almost certainly will not work, also the DK2 has that special portrait screen which your monitor probably is not… This splitter was made with DK1 in mind which has a more ordinary display.